7 Series E65 750i (N62TU) SAL
34 00 025
Replacing fluid in ABS/ASC+T brake system
Necessary preliminary tasks:
•
Read and comply with General Information
•
Remove air duct from microfilter on left
Observe safety instructions on raising the vehicle.
Important!
When carrying out repairs to the brake system, follow the
procedure set out in Bleeding brake system with DSC.
Connect bleeder unit to expansion tank and switch on.
Note:
Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.
Flushing brake system completely
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Open bleeder valve and purge until clear, bubble-free brake fluid
emerges.
Close bleed valve.
Follow same procedure on rear left, front right and front left wheel
brake.
RA Replacing fluid in ABS/ASC+T brake system
BMW AG - TIS
16.02.2013 05:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
